The EP Greenhouse gear driver is a compact and lightweight reduction gearbox with a built-in limit switch system that’s suitable for assembly of a locally available electric motor. The geared motor can be used in manually-controlled or climate-managed ventilation and display systems in greenhouses. The quick and easy-to-install EP gear reducer is rainproof and windproof. The gear driver has a high protection class (IP65) and can be utilized in an ambient temperature of 0-60 °C.

The low-noise gearbox for Greenhouse has a gearwheel transmission and a worm wheel transmission, which are integrated in an aluminum precision housing. The self-braking worm wheel transmitting means that the drive shaft is usually locked when the decrease reducer is not running. The completely sealed reduction gear motor comes with an expansion chamber with a diaphragm to keep the gear oil at a low pressure under all situations, even at high temperatures. Thanks to the use of an growth chamber, the gearbox could be installed in any placement. There are no limitations, since there is no need for a bleed plug. The sealed reduction gear reducer keeps the apparatus essential oil of the gear motor in optimum condition for its entire operating life time. The gearbox is ideal for discontinuous use, working class s3-30%, with a maximum activation period of 25 minutes.

The Gear box reduction gearbox has an FT85 motor assembly flange, on to which a suitable IEC standard motor can simply be installed (EN 50347).

The Gear box has a rotating limit switch system with operating switches and circuit breakers (NC contacts) for turning off by the end positions. The limit switch system is installed within an integrated chamber and is certainly enclosed by an impact-resistant plastic material cover. The limit switch system is accessible and easy to adjust. The limit change system’s maximum switching range is certainly 40 or 64 revolutions of the drive shaft. The cabling is linked in spring-clip connections. The gearbox has an IP68 M16 x 1.5 cable gland (5-9 mm cable) for the cable feed-through.

The gear reducer for greenhouse comes with 16 teeth 5/8”x3/8” sprockets, keys and fasteners. The accompanying chain couplings and assembly plates are available as accessories.

Optimum drive torque of 150 Nm or 450 Nm.
Rotational speeds of 3 or 5 rpm for a mains frequency of 50 Hz or 3.6 or 6 rpm for a mains frequency of 60 Hz in the event of software of 4-pole electric motor.
Protection class IP65.
Can be used in ambient temperatures of 0-60°C.
Ideal for discontinuous use, operating class s3-30%, maximum activation time 25 a few minutes.
Equipped as standard with 16-tooth galvanised chain coupling 5/8″x3/8″.
FT85 motor assembly flange for installation of IEC standard motor (EN 50347).
Maximum switching range of limit switch system 40 or 64 revolutions of the drive shaft.
IP68 M16x1.5 cable gland for cable feedthrough (5-9 mm cable).