rotary cutter gearbox

rotary cutter gearbox
RC-20 Collection
Requirements
Torque: 1,750 – 3,267 lb.-in.
198 – 369 Nm.
Ratios: 1:two.5, 1:2.eighty three
Seals: Triple Lip Spring Loaded
Bearings: Deep Groove Ball
Oil Cap: 16 oz. (.47 L)
Excess weight: 34 lbs. (15.four kg)
Programs
Ending Mowers Rotary Cutters
Rotary Slashers Toppers
RC-27 Sequence
RC-thirty Collection
Requirements
Torque: 2,800 – four,667 lb.-in.
316 – 527 Nm.
Ratios: one:1.forty seven, one:one.seventy one, 1:1.ninety three
Seals: Triple Lip Spring Loaded
Bearings: Deep Groove Ball
Oil Cap: 23 oz. (.sixty eight L)
Weight: fifty one lbs. (23.1 kg)
Programs
Finishing Mowers Rotary Cutters
Rotary Slashers Toppers
RC-51 Collection
Requirements
Torque: two,800 – 4,667 lb.-in.
316 – 527 Nm.
Ratios: one:one.47, one:1.71, 1:1.93
Seals: Triple Lip Spring Loaded
Bearings: Tapered Roller/ Deep Groove Ball
Oil Cap: 27 oz. (.eighty L)
Weight: 56 lbs. (25.4 kg)
Programs
Rotary Cutters Rotary Slashers
Gears: Offered with either straight bevel or spiral bevel gearing.
Electrical power: Hp & Torque dependent on AGMA formulation for continuous duty additionally a provider or load course issue.
Shafting: A variety of dimensional, metallurgical, and warmth-deal with alternatives available.
Bearings: Geardrives accessible with numerous bearing existence possibilities.
Lubrication: Drives offered with different lubes depending on working traits

Replacement Rotary Cutter gearbox, 40hp rated, 1-three/8″-6 spline input shaft, 1.fifty seven” X twelve tapered spline output shaft and 1:1.47 velocity up ratio. These gearboxes have a sq. housing configuration and are identical in mounting and ratio to the round configuration gearboxes. These are first gear gearboxes on the IM402, IM502 and IM602 sequence rotary cutters which highlighted slip clutch PTO shafts. This gearbox will not match the IM400, IM500 and IM60 types as they have a smooth input shaft! If your gearbox has a 12 spline output shaft and a 1-three/eight” – six spline input shaft this gearbox will perform. Bolt sample is 4-3/4″ on centre hole to gap and six-3/four” center to middle of bolt gap on diagonal. The mounting holes form a square bolt pattern.

Love rotary cutter gearbox as well as would love to figure out even more?